Wanner™ Hydra-Cell Pumps Videos

Wanner™ has created over 2 dozen YouTube videos which we have categorized below for ease of access and viewing.

 

Installation: Recommended pump system characteristics (2 min)

 

Demonstrations

• Demonstration of operating pump dry (30 seconds) (Hydra-Cell^® pumps are not damaged by running dry)

• Demonstration of cavitation (45 seconds) (Hydra-Cell pumps are unharmed by cavitation)

• Demonstration of Hydra-Cell design (1 min) with cut-away pump

• Demonstration of Hydra-Cell metering pump design compared to other designs (2 min)

• Animated Demonstration of the T100/200 pump design (1 min) Redone with oilfield installation examples (2 min)

• Demonstration of suction lift and performance with aerated/outgassing liquids, cavitation, dry running, smooth laminar flow, pumping viscous liquids (4 min)

 

Pump Repair

• T100 & Q155 Liquid End Service (28 min)

• T100 bias rod retrofit (7 min)

• T100 power end inspection (30 min)

• 9 part series using model H25 as an example (also applicable to D10, D12, & D40 pumps)

  • Chapter 1: Overview of Hydra-Cell pump and nomenclature (3 min)

  • Chapter 2: Fluid end service: Remove pump manifold, valve plate and check valves (9 min)

  • Chapter 3: Fluid end service: How to analyze and replace diaphragms (6 min)

  • Chapter 4: Fluid end service: Priming the hydraulic cells (5 min)

  • Chapter 5: Fluid end service: Reinstall valve plate and manifold (3 min)

  • Chapter 6: Hydraulic end service: remove camshaft assembly and inspect (7 min)

  • Chapter 7: Hydraulic end service: reassemble and install Hydra-Cell pistons (2 min)

  • Chapter 8: Hydraulic end service: reassemble cam assembly and Cylinder (9 min)

  • Chapter 9: Troubleshooting Hydra-Cell pumps (5 min)

 

Pulseless Metering Pump Model MT8

• MT8 fluid end priming (6 min)

• MT8 hydraulic end priming (11 min)

• MT8 diaphragm replacement (11 min)

• MT8 check valve replacement (11 min)